If a printer is installed in the unit it has to be enabled

To make sure it is enabled (see Main Settings Menu, sec. 2.6)

At the end of each cycle, the printer  (optional, standard on PRINT models) will produce a report containing information about the cycle that just ended. 

Printing starts when STOP is pressed, or, for cycles that end with drying phases, also when the door is opened.

The printout provides all the information needed to document the cycle: 

• the date and time

• the SterilClave model

• the serial number

• the cycle in progress

• the sterilization time

• the sterilization temperature

• the cycle number

• whether or not drying is scheduled

• the description of each phase, with start time and the temperature and pressure values

• in sterilization, the minimum and maximum pressure, temperature, and theoretical steam temperature values will also be printed 

• the total cycle duration, with the date and time the cycle ended

• the load

• the operator 

 

The information on time, pressure, and temperature is printed each time the phase changes or after each minute in the cycle has passed, depending on the option selected in the Main Settings Menu for the Data logging parameter. In the case of an ALARM, the printout will show the code for the alarm that was triggered. 

Operation 

 

When printing, the screen will read:  "PRINTING"

 

 

The sterilizer then changes to STAND BY mode.

To insert or replace a printer 26 paper roll, simply open the print door and then the interior printer door.

Both of these tilt downward. Insert or replace the paper roll with a compatible replacement (thermal paper) and thread one end through the upper slot.

Press the FEED button on the printer to advance the paper through the slot in the door.

Then close the door on the printer and the door of the control panel.